Godrej Smart Busduct System
S.M.A.R.T. BUSDUCT / rising main system are made of high quality "F" class extruded epoxy insulation and available with copper and aluminum conductor. The design is compact and sandwiched with simple structure and easy joint systems. Godrej S.M.A.R.T. Busduct System has been established in the Indian markets since 2001 and is approved by the CRPI for 100kA short circuit rating and temperature rise test for both Aluminium and Copper conductors.
Our Products for Low Voltage Electrical Bus duct, :
Rating : 1.1 KA, 1KA to 5KA,
Application : Busway (Sandwich construction) from a compact, reliable, low reactance connection between transformers, panels and small size Generators.
They are ideally suited for power distribution in high rise buildings, factories, commercial complexes and utilities.
Features : Low Reactance and Extremely Compact.
Construction : Conductor "Conductor-Extruded Aluminium or Copper Section"
Enclosure "Extruded Aluminium Sections / Galvanized Sheet Steel profiles.
Conductor Insulation "Mylar" & "Class F Epoxy Insulation 1.6mm by Extrusion Machine"
Supports Structures "Painted or Galvanized Steel"
Accessories : Bend, Elbows, Tees, Flanges End Caps, Phase-Crossover, Expansion Joints, Tap-Off Boxes, Fixed & Spring Supports, Wall & Floor Seals
Standard (Indoor & Outdoor) support arrangements from Wall, Ceiling & Floor, etc.
Rating . : 400 - 6300 Ampere (Copper) & 400 - 5000 Ampere (Aluminium)
The Sandwich Busways are designed to operate in the most onerous environmental conditions and meet the stringent international specifications.
They meet the requirements of IEC – 439 ( Part II ).
The Busways have been Type Tested for a wide range of parameters.
The enclosures are made out of extruded Aluminium sections. This provides structural rigidity and dimensional stability apart from a very aesthetic look. The extruded busbars are formed, sandwiched with requisite insulation, pressed inside the enclosure and riveted to provide a compact Busbar System.
The Aluminium enclosure provides protection against the most onerous atmosphere. All hardware and fixings on the enclosures are made of stainless steel to prevent occurrence of corrosion.
The Busways are manufactured in standard Lengths, Horizontal & Flat bends, Tees, Expansion Joints and Terminations arrangements. These can be supported from ground, ceiling or from roof with standardized rolled steel sections for ease of installation.
Busways when used as Rising Mains are provided with standard Tap-Off arrangements. These can be either in Fixed or Plug-in version. Fixed and Spring Loaded supports are available for supporting the Busways in vertical configuration. Tap-Off boxes with Switch-Fuse units or Moulded Case Circuit Breakers are available for downstream distribution.