Product Specification Digital Dynamic Slot Insize DIN 862
Digital Dynamic Slot Insize DIN 862
It is the standard used by most manufacturers as reference and testing standards as well as the most sought after in the hardware tool shop. DIN 862 does not have any special requirements for repetition. Two important factors that have a direct impact on measurement accuracy are the ability to establish uniform measurement pressure and surface caliper measurements in relation to the reference (measuring beam or ring gauge).
In principle all surface caliper measurements (external, internal and depth) should be calibrated. However, since the same scale is being read, then simply calibrate it once. The scale is usually calibrated at some point with the jaw for external measurements. If there is more than one set of jaws for external measurements then the longest one should be selected. Other measurement surfaces require only calibration at one or two points. Stores of engineering tools such as ours have a digital thrust range whose results are shown on the scale and digital display and deviations on the reference are recorded. The accuracy of the reading will depend on the quality and the display principle.
Resolution: 0.01mm / 0.0005 "
Buttons: on / off, zero, mm / inch
Automatic power off, move the digital unit to turn on power
USB data output
Made of stainless steel
Optional accessory: SPC cable (page A1-A2)
Price Digital Dynamic Slot Insize DIN 862