Lathe Machine Spare PartsIn general, a lathe has several main parts. For that make sure to use quality spare parts such as spare parts for Kennametal lathes. To make it easier for you to find out the main spare parts of a lathe, here is the discussion:1. HeadstockHeadstock is a spare part of a lathe that is used as a place for motion transmission that regulates the rotation required during the turning process. The headstock is used as a chuck and spindle holder, setting the spindle rotation speed, for gear box equipment, and so on.2. TailstockTailstocks are used to support long workpieces, position drill chucks, reamers, and for the tapered lathe machining process on lathes.3. ToolpostToolpost is a lathe spare part that functions as a chisel housing, which is used as a lathe chisel holder, using a chisel holder.4. SpindleThe spindle is used as a place to install the workpiece for the cutting process. There are two kinds of spindles, namely three-jaw spindles and four-jaw spindles.5. Lead CrewThis lead crew is a long threaded shaft located slightly below and parallel to the edge, extending from the fixed head to the fixed tail. Connected by gears on fixed head and rotation can be reversed. Attaches to the carriage and is used as a guide cable to create yarn only and can be removed when not in use.6. FeedrodThe feedrod is located under the guide threads. The feedrod is part of the lathe spare part which functions to transmit power from the fast gear box to move the deck mechanism in a transverse or longitudinal direction.7. CarriageThe carriage consists of a sled, tool holder and apron. To withstand the load and direct the carriage cutting tool must have a strong structure. Carriage is a lathe spare part that has two cross slides that function to direct the chisel to the cross direction. The upper spindle controls the movement of the tool mount and the upper spindle to move the stand along the base.8. Machine PedestalBed or pedestal is a spare part of a lathe that functions for a sled or carriage position. The machine base is part of the main frame of the lathe, on which the carriage and headstock rest and move, while the groove for the machine base is V-shaped, flat or flat.9. GearboxThis gear box or gear is a lathe spare part that functions to transmit power from the spindle to the main screw at different speeds.10. ChuckA chuck is basically a lathe spare part for clamping workpieces, especially those of short length and large diameter or irregular shapes that cannot fit comfortably between centers. It can be attached to the lathe by tightening at the end of the spindle.
Click the number to directly contact the supplier
Anda hampir selesai membuat RFQ