Concrete Vibrator

How to Use a Good and Correct Concrete Vibrator:

1. Insert the vibrator through the concrete vibrator hose into the concrete that has been poured in a fast time, then lift the vibrator slowly during the compaction process.

2. Avoid the vibrator tool in contact with the surface of the formwork, this is to anticipate so that unnecessary vibrations occur which can result in small cracks after the concrete compaction process.

3. The vibrating process can be carried out at regular distances and the vibration time at each point is 5 to 15 seconds, do it periodically.

4. It is not allowed to increase the length of time to avoid bleeding.

5. In order not to damage the iron adhesive with one another, then avoid the vibrator of the iron.

6. Adjust the thickness of the concrete to be poured with the length of the vibrator rod, because the depth of the vibrator rod must be within reach of the concrete base so that it does not touch the surface of the formwork.

7. Compaction that is too short can result in the concrete being porous.

8. Maintain the stability of the vibrator so that there is no push of the vibrator rod while inserting it into the cast concrete.

9. Avoid pulling the vibrator rod in a horizontal position, do so at an angle to avoid the mortal channel (concrete mixture is knocked out of the horizontal pull) when removing the vibrator.

If you need a concrete vibrator, you can use Daiho's concrete vibrator, Wacker Neuson's concrete vibrator, and Mikasa's concrete vibrator.